How to Calibrate Your RunPod - Instructions | Zwift (2024)

Want to run on Zwift? Just grab a Zwift RunPod and you’ll be off and Zwifting in no time. Follow these instructions to learn how to calibrate your RunPod.

1. Connect your RunPod to Zwift. Just go to the pairing screen to do this.
2. Find the calibration button on the pairing screen. It’s the button with the wrench on it.
3. Push the calibration button.
4. Zwift will bring you to the Calibrate Device screen. Use the Up and Down arrows to select a speed you can comfortably run at
   for a few minutes.
5. Select Next and follow the on-screen prompts.
6. Set the treadmill to the running speed you selected.
7. Run at that speed for 40 seconds. Do not stop your treadmill.
8. You'll be prompted to set your treadmill to a second speed.
9. Run at that speed for 40 seconds.
10. You'll be prompted to set your treadmill to a third speed.
11. Run at that speed for 40 seconds.
12. When the "Calibration Complete" message appears, select OK.
13. If you run into an issue, restart the calibration process.
14. When the Paired Devices screen loads again, select OK.
15. Good job. You calibrated your RunPod. It’s time to get out there and knock out a few miles.